Our certified pool contractors can assist other pool contractors who don’t perform plastering, tiling, or coping. We can help finish your pool job with the final touches. Visit our pool contractors page to find out more about how our pool renovations can help you!
We design and build breathtaking cabanas, fireplace, outdoor kitchen, bars, and other structures. Our full design services are available to you. Our professional landscaping and hardscaping can transform your property into a beautiful view for your family to make memories for many years to come.
One of our professional renovation consultants will meet you at the property, inspect the pool, and make recommendations. After that, we will provide you with an estimate specific to your needs. You will have the opportunity to go over plaster, tile, and copying options.
Your signed contract will be given to our schedule department, which will contact you to provide you with your starting date and provide additional information.
If you want to replace your tile, our removal team will arrive at your property and remove the tile and coping as needed.
Our installation team will arrive at your property and install the tile of choice and coping.
If you are re-plastering your pool, our plaster resurfacing team will arrive at your property and chip/cut as needed, inspect the pool for hollow spots and apply bonding cement to the surface if needed.
Our professionals will come and pump the new plaster into the pool and hand trawl until a smooth surface has been achieved.
If required, our team will arrive at the property to install new self-leveling caulk between the coping and expansion joints.Plaster Renovation Start-Up Procedures.
Once the pool finishes it starts to hydrate immediately after mixing. This period when a plaster finish is most susceptible to staining, scaling, and discoloration. A proper start-up procedure including timely brushing and constant monitoring and adjusting of the pool water is mandatory. The following are partial recommendations taken from the National Plasterers Council.
We make sure the filtration equipment is operational.
We remove all floor heads and directional eyeballs.
Based on temperature and type of finish, we then fill the pool based on a specified water level without interruption as rapidly as possible with clean potable water to help prevent a bowl ring. We place a clean rag on the end of the hose, always placed in the deepest area, to prevent damage to the surface material.
During that period no one is allowed in the pool during the fill. Also do not allow any other objects of water to enter the pool to help prevent streaking. Do not swim in the pool until the water is properly balanced.
Start the filtration system immediately when your pool is getting full in the middle of the skimmer or specified water level.
If you are looking for a pool contractor that cares about you understanding the process please look no further and call our office to schedule an appointment for a pool renovation professional to assist you.
Philadelphia Pool Builder is the best service provider for those who want smart solutions to enjoy, improve, and maintain their pool.
1234 Market St, Philadelphia,
PA 19107, USA
Mon-Fri 9AM - 6PM